[Steam-engine] Gauge tools

[Andre Blanchard]

Here is a place that sells clock repair tools.
http://shorinternational.com/WatchClockRemovers.htm
There is a hand removal tools about half way down the page.  The one that
looks like it was sawed off a length of pipe with a tapped hole in the side
should only take a few minutes to make.

Thanks,
Andre' B.  Clear Lake Wis.
 

-----Original Message-----
From: steam-engine-bounces at lists.stationary-engine.com
[mailto:steam-engine-bounces at lists.stationary-engine.com] On Behalf Of Andy
glines
Sent: Tuesday, June 29, 2004 3:26 PM
To: Steam-engine mailing list
Subject: Re: [Steam-engine] Gauge tools

Bruce, where do I get a hand-jack?

--- Bruce & Marlene Babcock <babcock2 at gte.net> wrote:
> 
> At the National Threshers show at Wauseon last
> weekend I had a small exhibit
> of steam gauges.   Part of the exhibit included
> three gauges that had been
> damaged by improper use or maintenance.   One of
> these had a bent hand shaft
> and a scratched dial which may have occurred when
> someone tried to remove
> the hand without using a hand-jack.  Be extremely
> careful if you try to use
> screwdrivers instead of a hand-jack!
> 
> Bruce E. Babcock
> 


=====
Andy Glines
Evansville, IN


		
__________________________________
Do you Yahoo!?
Yahoo! Mail - 50x more storage than other providers!
http://promotions.yahoo.com/new_mail
_______________________________________________
Steam-engine mailing list
http://www.stationary-engine.com/mailman/listinfo/steam-engine