[AJD] JD 530 Outer Rear Bearing race

Brian VanDragt bvandragt at intraworldcom.net
Wed Jun 16 18:50:53 PDT 2004


Ken,
Do you have a welder?  Run a bead of weld around the inside of the race and
after it cools you should be able to pull it out by hand, or you can also
weld something onto it to pull on.  The weld will shrink the race so it
comes out easily.

Brian VanDragt

----- Original Message ----- 
From: "Kenneth Jones" <kenejons61 at yahoo.com>
To: <antique-johndeere at lists.antique-tractor.com>
Sent: Wednesday, June 16, 2004 9:41 PM
Subject: [AJD] JD 530 Outer Rear Bearing race


> Appreciate any suggestions that you guys might have on removing the outer
rear axle bearing race on my 530.  The housing is cast without any
indentations where you can locate a puller. I suppose that I could take a
torch and cut the race but I am not to sure about the casting.  Appreciate
any assistance....
>
> Thanks
>
>  Ken Jones
>
>
> ---------------------------------
> Do you Yahoo!?
> Yahoo! Mail Address AutoComplete - You start. We finish.
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>




More information about the AT mailing list