[AJD] JD 530 Outer Rear Bearing race

[Bruce Mahr]

Run a bead of weld around the center of the race, and it will shrink so that
you can pull it right out.

Bruce Mahr
----- Original Message ----- 
From: "Kenneth Jones" <kenejons61 at yahoo.com>
To: <antique-johndeere at lists.antique-tractor.com>
Sent: Wednesday, June 16, 2004 8:41 PM
Subject: [AJD] JD 530 Outer Rear Bearing race


> Appreciate any suggestions that you guys might have on removing the outer
rear axle bearing race on my 530.  The housing is cast without any
indentations where you can locate a puller. I suppose that I could take a
torch and cut the race but I am not to sure about the casting.  Appreciate
any assistance....
>
> Thanks
>
>  Ken Jones
>
>
> ---------------------------------
> Do you Yahoo!?
> Yahoo! Mail Address AutoComplete - You start. We finish.
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>