[AT] How to seat the bead on lawn tractor tires?

[Spencer Yost]

I always had luck with the rope and stick thing.   If I do it tight enough,
then hit it with everything my air compressor gives out, I have been able
to do it.  By the way, I take the valve out and place a blowgun on the stem
for fast air attack, though usually even just leaving the valve in and
using the regular filler/gauge does the trick. Sounds like you have a
strange tire size that doesn't yield as easy.

A tube will seat it too if one will work in this situation, even if the
tire doesn't usually need one.  That's always a cheap $5-8 fix.

The gas trick I've never tried but I have tried the ether trick - Much more
flammable, explosively so, and may make the difference.  Be darn careful
though please

Good Luck,

Spencer Yost
Owner, ATIS
Plow the Net!
http://www.atis.net

*********** REPLY SEPARATOR  ***********

On 7/22/2004 at 8:57 AM Matthew wrote:

>I just got a pair of old lawn tractors (Ariens Emperors) and the tires
>are 
>pretty dry rotted on them.  These things are built solid as a rock so I am

>in the process of restoring them back to running condition.
>
>I put a new rear tire on one of them, and it turned out to be a most of
>the 
>afternoon project.  Getting the old tire off, and the new one on was easy 
>enough.  Getting the bead started was the fly in the ointment.  
>
>I started with crossing my fingers and hoping that my compressor would 
>blast it hard enough to get both sides to catch.  Not a chance.
>
>Next, I tried a ratcheting tie down around the center to pull the beads
>out.
>This looked like it was going to work, but you reach a point (before the 
>bead starts to catch) where pulling the center in starts to pull the beads

>in too.
>
>Next, the pyro in me came out and I tried the gas trick.  I have had good 
>results with this on car and cycle tires, but there is something bout the 
>fat little tires that keeps it from getting a good pop..  
>
>I resorted to beating on it with a mallet for a while.  It did no good,
>but 
>I got some aggression out.
>
>In the end I got it, with a rope around it, and a bunch of sticks to twist

>the rope with.  As soon as the bead would start to cave in someplace, I
>would 
>loosen the whole thing up and stick a stick in that place and start over. 
>3 
>or 4 sticks later and I was able to get just enough air in to get it to
>seat.
>
>Once it is that far, you are home, but what a long, drawn out trip it was.
> Is 
>there an easier way to get these things to seat?
>
>--Matthew
>
>
>_______________________________________________
>AT mailing list
>http://www.antique-tractor.com/mailman/listinfo/at