[AT] Hyd. Cylinder Rebuild
HaliganBar at aol.com
HaliganBar at aol.com
Sat Feb 21 00:57:12 PST 2004
Thanks Walt! I was hoping it would be that straightforward but, I knew I
better check...my luck isn't always good with new stuff. ;-) So, I should be okay
using the small burr and the Dremel?
Karl
In a message dated 2/21/04 2:06:08 AM Eastern Standard Time,
DAVIESW739 at aol.com writes:
> You can grind it out so that the threads are clear of any damage. then
> remove
> the piece. You can pick another spot to stake it if you want to the
> loctite
> will break down under heat and age.
> Walt Davies
>
More information about the AT
mailing list