[AJD] Looking downstream - Heat

[Robert M. Massengale]

Having read lots of other posts about loosening frozen nuts and bolts and 
understand the three main ingredients are patience, penetrating oil and heat.  I 
expect I'm going to be up against some of those hard to remove/loosen nuts & bolts 
pretty soon and will need a heat source.  The best I have right now is a small 
propane torch I purchased to make some plumbing repairs to copper pipe, but 
suspect that it will either not be up to the task or not economical in the long run for 
working on my B.  I have no welding skills, so I don't need one of the large gas 
welding rigs... I don't think.  If I find I need to develop some welding/brazing skills I'll 
upgrade to meet those needs.  In the meantime I think all I need is a good heat 
source to apply to those frozen nuts and bolts and am looking for suggestions and 
recommendations from the list.  If you think I'm being short sighted please say so 
and recommend some more appropriate equipment.

Thanks in advance,

Mike
Robert M. Massengale
Fredericksburg, Texas