[AT] Grease fitting threads

[Len Rugen]

I tried Spencer's idea, I've always thought you could fix anything with a
hammer anyway.  It looks like it will hold the zerk in, but when I tried to
grease it, it pushed grease around the zerk.  It may be so cold that the old
grease isn't moving.  I left it this way, next time I run it and get
everything heated up, I'll try greasing it warm.

The zerk is already in a small indention on the casting.  My new guess is
that someone chained the front axle down hauling the tractor and the chain
broke it off.  It's not as exposed as I thought, unless it had a 45 degree
zerk, which would stick out further.

I quickly discovered that my sore sholder is still sore.  To get to this, I
have to lay down and work over my head.  OUCH....

---
[This E-mail scanned for viruses by Declude Virus]