[Ford-ferguson] Resistor & condenser 8N

[Ace Russell]

Sorry for all these basic questions, but while shopping online, I saw a kit
for converting to electronic ignition. What are the pros and cons? Is that a
project for an amateur?

Ace


> -----Original Message-----
> 
> Hey you guys want to change points and condenser on front mounted 
> distributors the right way? unsnap cover - remove coil - disconnect 
> primary wire - remove the two cap screws and remove the whole 
> distributor and take to workbench - IT FO4 manual show procedure to 
> check timing if you want check but not necessary. The drive tang is 
> offset and will only go in one way. So when putting back, slow turn 
> rotor until it drops in slot on camshaft - put bolts back in - coil - 
> cap - wire Point Gap .014 - .016 Make sure if you replace spark
> wires - use only copper wire not carbon automotive wires.
> 
> Dick
>