[AJD] Decal Placement

[David and Shelly Battenberg]

Duane,

I am also in the process of placing decals on my 1940 H and actually was
wondering the same.  I got my decals from Jorde and also have the decal you
are referring to.  On the picture I received from Jorde noting the placement
it says to put in on the "differential cover".  Hope this helps.  I have PTO
on mine, so placement may be different?

David Battenberg
Clintonville, WI
----- Original Message ----- 
From: "Duane Ledford" <dledford at classicnet.net>
To: "Antique John Deere mailing list"
<antique-johndeere at lists.antique-tractor.com>
Sent: Saturday, August 07, 2004 11:04 PM
Subject: Re: [AJD] Decal Placement


> Duane,
>
> That's the decal. That's where I thought it should be, but will check with
> K&K Monday to be absotively shure.  Thanks for the info.
>
> Duane Ledford
>
> ----- Original Message ----- 
> From: "Duane Larson" <jdlarson at comcast.net>
> To: "Antique John Deere mailing list"
> <antique-johndeere at lists.antique-tractor.com>
> Sent: Saturday, August 07, 2004 10:49 PM
> Subject: Re: [AJD] Decal Placement
>
>
> > Duane,
> > A 1939 H advertising booklet shows a decal  which looks like
> >
> >     John     Deere
> >         pix of leaping deere
> > Moline     ILL
> >
> > and it is placed on the back cover centered between the bottom 4 bolts
> > holding the cover on.  The words John Deere are placed at an angle in
the
> > usual way.
> >
> > However, it is a faint pix and it would be good to verify with Kent
before
> > placing it on.
> > Regards,
> > Duane Larson
> >
> > ----- Original Message ----- 
> > From: "Duane Ledford" <dledford at classicnet.net>
> > To: <antique-johndeere at lists.antique-tractor.com>
> > Sent: Saturday, August 07, 2004 10:37 PM
> > Subject: [AJD] Decal Placement
> >
> >
> > Putting the decals on my 1940 H this afternoon when I ran into a
problem.
> > The decals I received from K&K included a "leaping deer" decal. The
> > instructions say that it goes on the transmission housing and that it
was
> > for the 1939 and 1940 models only. I can see no place on the
transmission
> > housing that this decal could fit. The only place that it would fit
would
> be
> > on the crankcase cover or the rear end cover. Was there possibly a
serial
> > number break in 1940 where they changed the configuration of the
tractor.
> I
> > know that the  '39's were different than all the rest. Any insight would
> be
> > helpful. I'll call K&K Monday about this, but thought I could get some
> help
> > from all of you before then.
> >
> > Thanks,
> > Duane Ledford
> > _______________________________________________
> > Antique-johndeere mailing list
> > http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> >
> > _______________________________________________
> > Antique-johndeere mailing list
> > http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> >
>
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>