[AT] 630 handclutch and charging problem

[HaliganBar at aol.com]

I seem to remember a similar thread on the list quite a while ago. If I'm not 
mistaken you should also check the voltage output of the generator. Putting 
out 10 amps isn't much good if the generator is only putting out 2 volts. 
Someone correct me if I have this wrong.

Karl

<< Ricky:
 
 If it is positive ground and when the tractor is running at high rpms
 and
 shows a +10 amp charge, probably nothing needs to be done. How long did
 you
 run the tractor at high rpms vs putting the charger on the battery for
 an
 hour. How many amps was the charger putting out? I would suspect the
 battery
 is low after having been setting around. Will take a few hours of
 tractor
 running time to get it to be fully charged up. You may not have a
 problem at
 all other than giving the tractor some running hours to perform its
 task.
 Patience may be a virtue here.
 
 Dean A. Van Peursem
 Snohomish, WA 98290
  >>
_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at